Protection & Controls System Tech I
OPEN REQUIREMENTS:
Possession of a two-year technical school degree in electrical, electronic, communications, computer technology, or related field.
OR
An Associate's Degree in electronics, electrical, communications, computer engineering technology, or a related field
OR
Successful completion of Military Power Training School in Electrical, Electronic, Communications, or Computer Technologies
LICENSING/CERTIFICATION/REGISTRATION\:
A valid driver's license is required prior to employment and must be maintained during employment in this classification.
This is a Safety Sensitive Position - Design, construction, maintenance, inspection & operation of systems carrying current, fluids, or gas that could endanger the public.
RATE OF PAY: $39.84/hr
PHYSICAL REQUIREMENTS:
Sitting |
Up to 6 hours per day |
Lifting |
Up to 2 hours per day |
|
Walking |
Up to 6 hours per day |
|
Up to 50 max. pounds** |
|
Standing |
Up to 6 hours per day |
Pushing |
Up to 2 hours per day |
|
Bending |
Up to 6 hours per day |
|
Up to 50 max. pounds** |
|
Squatting |
Up to 6 hours per day |
Pulling |
Up to 2 hours per day |
|
Stooping |
Up to 6 hours per day |
|
Up to 50 max. pound** |
|
Reaching |
Up to 6 hours per day |
Climbing |
Up to 2 hours per day |
|
Balancing |
Up to 6 hours per day |
Stairs |
Up to 2 hours per day |
|
Twisting |
Up to 6 hours per day |
Ladder |
Up to 2 hours per day |
|
Crawling |
Up to 6 hours per day |
Step-stool |
Up to 2 hours per day |
|
Kneeling |
Up to 6 hours per day |
Excessive heat |
Up to 10 hours per day |
|
Typing |
Up to 6 hours per day |
Excessive cold |
Up to 10 hours per day |
|
Data Entry |
Up to 6 hours per day |
Dust |
Up to 10 hours per day |
|
|
|
Humidity |
Up to 10 hours per day |
|
|
|
Loud Noise |
Up to 10 hours per day |
|
|
|
Hands in Water |
Up to 1 hour per day |
|
Unusual hearing or vision demands: |
Ability to maintain correctable 20/40 vision and distinguish basic colors; good depth perception; normal hearing. |
|||
Other physical demands or notes: |
Required to pass a qualitative respirator fit test with ability to wear a respirator without respiratory distress. Ability to perform strenuous physical activity; carry, lift, and set up 50- pound relays; lift test equipment in excess of 70 pounds; and work at heights up to 50 feet. Good hand and eye coordination. **JEA employees should not attempt to lift, pull, or push a load in excess of 50 lbs. without assistance. Care should always be taken when lifting, pushing or pulling in an awkward position. |
|||
- Installs, configures, tests, calibrates, maintains, inspects, troubleshoots, and repairs protective systems including but not limited to protective relays, associated communications circuits, voltage and sensing circuits, DC batteries circuits, DC control circuits, microprocessor based protective relay schemes, audio tone relay communication equipment, fault recorders, power line carrier equipment, reclosers, sectionalizers, instrument transformers, switchboard meters, annunciators, electronic tap changer controls, and other electrical and electronic equipment associated with protection systems.
- Installs, configures, tests, calibrates, maintains, inspects, troubleshoots, and repairs supervisory control and data acquisition systems including but not limited to microprocessor based remote terminal units, terminal units, process control, communication equipment, GPS clocks, communications processors/data concentrators, digital input circuits, analog input circuits, digital and analog output control circuits and other electrical and electronic equipment associated with supervisory control and data acquisition systems.
- Installs, configures, tests, calibrates, maintains, inspects, troubleshoots, and repairs metering and telemetry systems including but not limited to revenue metering equipment, analog telemetry equipment, transducers, communications equipment, instrument transformers, switchboard meters, and other electrical and electronic equipment associated with metering and telemetry systems.
Installs, modifies and checks equipment for new and upgraded electrical facilities. - Revises plans for as-built modifications.
- Obtains operational clearances as required.
- Performs switching to connect and disconnect feeder breakers to and from the transfer bus; to open and close 5kv-15kv metal clad breakers, including racking them in and out; and to operate disconnect switches for isolating circuit breakers, reclosers, transformers, potential transformers, and related substation equipment.
- Operates vital equipment to restore electrical power transmission and distribution circuit in emergencies.
- Participates in system restoration, as required.
- Maintains tools and equipment in safe and proper working condition.
- Complies with safety rules and regulations and employs safe work practices.
- Operates and maintains assigned vehicles.
- May be required to operate the relay shop electronic lab.
- Operates standard office equipment and uses required software applications.
- Performs other job-related work as assigned.